Securitron SP-1 User Manual download pdf

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader

Tel 800.624.5625 [email protected]

in door opening solutions

Page 1 Rev. D, 03/11

MODEL SP-1 TOUCH SENSITIVE WALL SWITCH

INSTALLATION AND OPERATING INSTRUCTIONS

1. DESCRIPTION

The SP-1 is a touch sensitive wall switch which is generally used as a superior alternative to wall

mounted mechanical push buttons. When touched by the human hand (even through gloves)

the unit operates a set of internal dry contacts. The unit includes an internal timer, an LED

which indicates operation and a redundant backup switch. The SP-1 is intended for indoor use

only.

FIGURE 1: SP-1 OVERVIEW

SEN

TIME

POT TO ADJUST TOUCH

SENSITIVITY

POT TO SET TIME

DELAY (1-35 SEC)

CONNECTION WIRE

FROM SENSOR TO

PLATE

CABLE

CONNECTOR

2. PHYSICAL MOUNTING

Identify the top of the unit by noting that the LED is on the top face of the backbox. Remove

the bottom screw of the plate. Note that the top screw includes a spring that goes around

the screw below the plate. Do not lose this spring as its presence is necessary for proper

operation. It is not necessary to remove the top screw with the spring on it, but to just loosen

this screw and rotate the plate enough to access the mounting screw points. Mount the unit to

the wall using the supplied screws. Note that there are two approaches to mounting. You can

use the holes at the diagonal corners of the box and optionally one of the interior holes for

surface mounting on dry wall or other material. #8 x 1 1/2" Sheet metal screws are provided

for this purpose. Alternately, if you are putting the SP-1 over a US type backbox, you can use

two machine screws (supplied) to mount into the standard backbox tab threads.

Note that the stainless steel plate must be isolated from any conductive (metal)

surface. At least one inch of separation must be maintained between the edge of the

plate and any protruding metal piece.

3. WIRING

The SP-1 has 6 colored wires which are for sensor power and DPST relay output:

Red - "+" DC Power

Black - "-" DC Power

White - Relay Common, Pole 1

Green - Relay Normally Closed, Pole 1

Blue - Relay Common, Pole 2

Orange - Relay Normally Open, Pole 2

1 2 3 4

Summary of Contents

Page 1 - Page 1 Rev. D, 03/11

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solution

Page 2 - WIRING FOR FAIL SECURE LOCK

PN# 500-15600 Page 2 Rev. D, 03/11 The relay has 2 amp contacts; the operation of the SP-1 is fail safe. When the SP-1 receives power, its con

Page 3 - Page 3 Rev. D, 03/11

PN# 500-15600 Page 3 Rev. D, 03/11 FIGURE 3: DOUBLE BREAK WIRING CABLERED (+ POWER)BLACK (- POWER)WHITE (RELAY COM1)GREEN (RELAY N.C.1)POWER S

Page 4

PN# 500-15600 Page 4 Rev. D, 03/11 7. ADJUSTING SENSITIVITY The sensitivity pot (see Figure 1) must be adjusted for proper operation. The set

Comments to this Manuals

No comments

Securitron SP-1 User Manual

Browse online or download User Manual for For Home Securitron SP-1. Securitron SP-1 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For Home Securitron SP-1