Securitron CCB_Series User Manual download pdf

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader

Tel 800.624.5625 [email protected]

in door opening solutions

Page 1 Rev. B, 07/11

CCB-8-12 / CCB-8-24 SLAVE BOARD

INSTALLATION INSTRUCTIONS

1. DESCRIPTION

The CCB-8-12/24 allows the addition of eight individually Polyswitched outputs to an existing

power supply. The power supply’s total current capacity remains the same. The CCB-8-12/24

may be installed into the existing power supply enclosure via the provided snap-trak. The CCB-

8-12/24 is not compatible with the Securitron 1 amp power supply.

FUSE

- +

SLAVE BOARD

MASTER BOARD

BLACK WIRES

RED WIRES

Figure 1

2. INSTALLATION & WIRING

It is recommended that the CCB-8-12/24 be mounted below the main distribution board. The

CCB-8-12/24 comes standard with four 8” flying leads. Prior to installation, ensure that you

have the correct version of the CCB board for the power supply as they are available in 12 VDC

or 24 VDC.

The CCB board has 4 wires (2 red wires and 2 black wires) which must be soldered to the main

distribution board. Remove AC power and disconnect the battery leads from the battery before

soldering. The 2 black wires should be soldered to the main board’s “S-” solder points. The 2

red wires should be soldered to the main board’s “S+” solder points (as shown in Figure 1).

Note: Any modification to the Power Supply including the addition of the CCB will void

the UL Certification.

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solutio

No comments

Securitron CCB_Series User Manual